Ademco 6160v user manual


B, ademco 6150V 6160V, voice Remote Keypad.
Wiring AND installation Keypads user can be surface mounted using drywall anchors or to a single- or double-gang electrical box.The recorded message registration will remain in unblocked memory until a new jeep message is recorded.When used with the vista-15P/vista-20P control panels, address 16 ademco must be assigned registration to the first Keypad.6160V: user 190mA tamil english (armed LED lit, LCD backlight unblocked and setup sounder on) reduces to 60mA when panel is operating in standby mode (backlight off).You must power down, power up, kannamai and start the address mode again.Route wiring from the control panel through the opening in the case back.The message can be up.5-minutes long.Note: Adjusting message volume also adjusts status volume.The default keypad address.Permanent display backlighting is an option on some controls (refer english to control panels device instructions for details). Mounting release snaps (Remove case back manual by pushing up the 2 "snaps" along the keypad's bottom edge and pulling the case apart.).


Sitemap