Manual bmw r50 5





Insert 4 rectangular pins from iPod harness honey (1) into radio harness deep (2) as follows: Color Location Description White/gray 9 I-Bus Brown 12 Ground Violet/white 16 KL-R Red/green 15 KL-30.
Note: Split grommet as shown before placing around iPod cable in order to deep prevent hunter damage to cable.Insert iPod cable (1) through hole in glovebox as indicated.(refer to mini iPod Interface Owners Manual) This iPod Interface is compatible with the fritz following software versions: o Gen3 iPod.Disconnect sims negative battery terminal.Troubleshooting iPod mode is not selectable from the radio until an iPod is connected.If you want to know more or withdraw your consent to all or some of instruction the cookies, please refer to the cookie policy.Print, print page 5, rename the bookmark, removal delete from my manuals?Insert white 12-pin connector (1) from iPod harness (2) into lower left section of radio connector (3).Development, subject iPod Interface Kit P/N.Remove the following components using information available in TIS: Drivers knee bolster (1) Center dash face (3) (Refer deep to RA62 21 001) Radio side pillars (4) (Refer to RA51 16 198) Radio (5) berserk (Refer to RA ) Glove box (6).Special tools, pin Removal manual Tool.Remove the blue lock (1) from radio harness by releasing tab and sliding upwards, then remove following terminals (2) using AMP berserk terminal removal tool p/n 61 1 134: Pin # Col.No methods other than those specified in this document are to be manual used for installation cell in mini vehicles. Left and right are determined from drivers seat.
Parts information, contents of Kit P/N.
Technical Hotline, along with VIN, date of manufacture and as much detail as possible.


Sitemap